Actron CP9449 ABS BrakeScan Manuale Utente

This QuickStart Guide was developed to help you get started using the BrakeScan Tool. If there are any problems following these steps or if extra inf

10Select the Make then press ENTER. Select the Model then press ENTER. Select the Engine then press ENTER. Note: If all engine types apply,

11Reading CodesReads DTCs from vehicle’s computer with key On and the Engine Off (KOEO) or Key On and the Engine Running (KOER).From the Diagnostic Me

12Within each category (Powertrain, Chassis, Body, and Network) of DTCs there are assigned ranges for different vehicles.Non-OBD II Format CodesDTCs c

13DTC ExamplesGeneral Motors provides additional information along with the DTCs:Current - A current DTC indicates that a failure is currently present

14This code indicates that you have had a problem with the Pump Motor Circuit long enough to be stored in long-term memory and that the problem is ill

15Use tLEFT or uRIGHT arrow keys to move to desired character.Use pUP or qDOWN arrow keys to change or select a character.Press ENTER.Note: If the

0002-000-3029© 2007 SPX Corporation®. All Rights Reserved.SPX Corporation Limited WarrantyTHIS WARRANTY IS EXPRESSLY LIMITED TO ORIGINAL RETAIL BUYER

2ContentsAbout ABS BrakeScan ...3About this Guide ...

3About ABS BrakeScanABS BrakeScan is the rst tool designed for Do-It-Yourselfers to access the ABS diagnostic information. The Tool retrieves codes f

4(master cylinder, shoes, pads, wheel cylinders, calipers, rotors, drums, and assorted hardware) work the same as they did before ABS. What has change

512345678User InterfaceENTER key - Selects displayed item.Data Link Connector Port - Provides a connection for interfac-ing with the vehicle. USB Port

6Display ElementsThe display has a large viewing area for posting messages, instructions, and diagnostic information. The following symbols may appear

7Locating the Data Link ConnectorThe Data Link Connector (DLC) is used with the Tool to communicate with the vehicle’s control module. Note: When usin

8Selecting a VehicleSelecting a vehicle is required to communicate with the vehicle and to correctly display DTC de nitions. During vehicle selection

9Erase previous vehicle diagnostic data.To erase the data stored from the prevous vehicle test press t LEFT for Yes. Then go to the section Reading C